| Frequency response |
0.5-20,000Hz ± +0
-.1dB |
| Distortion |
-.025% 1kHz |
| S/N ratio |
96 dBA |
| Phase linearity |
|
| Channel separation |
92dB 1kHz |
| Resolution |
24 BIT DELTA-SIGMA DAC
(Crystal Semiconductor 24/192 DAC) |
| Output impedance |
(Analog) 400 ohms BAL,
200 ohms SE |
| Analog outputs |
Balanced XLR 5.4V RMS
(+14.6dBv) max |
| |
Single-Ended RCA 2.7V
RMS (+8.6dBv) max |
| Digital outputs |
XLR Balanced AES/EBU
110-ohm 4V P-P |
| |
BNC coax SPDIF 75-ohm
0.7V P-P |
| Drive mechanism |
Philips CDM Pro2 cast
metal transport mechanism. |
| |
Optical pickup: 3-beam
LDGU (Laser Diode & Grating Unit), with holographic
diffraction light pen |
| |
Laser: GaAIAs
semiconductor, 780nm, 0.5mW maximum output |
| |
Servo:
Digitally-controlled low-inertia linear positioning actuator |
| |
Wow & flutter:
Unmeasureable (Quartz stability) |
| |
Jitter reduction:
High-stabillity crystal-controlled re-clocking for all
outputs |
| |
Discs: Accepts 5"
(12cm) and 3" (8cm) sizes |
| |
Display: Six-digit
vacuum fluorescent, with optical filter |
| Power requirements |
100-135VAC 60Hz
(200-270VAC 50/60Hz), 40 watts maximum. (26 watts standby) |
| Other |
Detachable power cord
Quantization Bit: 16bit linear per channel.
Channel bit rate: 4.3218Mb/sec
Channel modulation code: EFM (8 -14 modulation)
Error correction: CIRC (cross interleave Reed Solomon Code)
Compliance: RF Interference complies with FCC and CE MARK
It is better to leave it plugged into a live outlet at all
times for best sonics. After plugging it into a live outlet,
the CD3 (like the CD2) will mute its output for
approximately 45 seconds as the unit stabilizes.
The power cord is a grounded three pin 14 gauge cord with
detachable IEC connector.
Proprietary, self centering magnetic clamp. |
| Dimensions |
19" (48 cm) W x 5.25"
(13.4 cm) H x 12.25" (31.1 cm) D. Handles extend 1.50" (3.8
cm) forward of the front panel. Rear connectors extend .75"
(1.9 cm) |
| Weight |
25 lbs. (11.4 kg) Net;
35 lbs. (15.9 kg) Shipping. |
